Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

B3654 Engine Trouble Code

Meaning of B3654 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B3654 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for B3654 code is occuring now you should check B3654 repair processes.
Now don't ask yourself; What should you do with B3654 code ?
The solution is here :

B3654 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B3654 Code Meaning :

B	3	6	5	4
OBD-II Diagnostic Body (B) Trouble Code For Engine	Ignition System Or Misfire	Fuel Temperature Sensor B Circuit Range/Performance	Cylinder 1 Injector Circuit Low	Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B3654 OBD-II Diagnostic Body (B) Trouble Code Description

B3654 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For B3654 Code

The reason of B3654 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

B3654 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

	Example: 0140